Oratape is a clear PVC based self-adhesive transfer / application tape. The 100 micron film features a solvent polyacrylate adhesive that gives medium adhesive strength. It is perfect for applying vinyl decals to a variety of surfaces and can be re-used over and over again.
It has a block pattern backing which makes cutting a breeze, ensuring your cut lines are straight and making measuring easy.
This transfer tape is suitable for use with a variety of adhesive vinyls and can be removed without leaving a sticky residue on surfaces or decals.
It is the perfect accessory for your vinyl cutters and plotters including Cricut, Brother and Silhouette, and a must for every crafter.
- Suitable fo use with a variety of adhesive craft vinyls
- Clear film that allows for easy placement of decals
- Blocked backing for easy cutting and measuring
- Can be re-used multiple times
- Won't leave a sticky residue on decals or surfaces
- Medium grip tape
Transfer Tape - Application tape 300mm wide
Lay the vinyl sheet backing side down on your cutter mat.
Cut your design and remove from the cutting mat.
Weed the design to remove unwanted vinyl. This should be done with a weeding tool. A light box may make it easier to see the design and allow for easier weeding.
Apply your transfer tape to the front of your design and use a scraper to make sure the design has adhered to the tape.
Ensure your application surface has been thoroughly clean and is free from dust, grease and any residue or contamination that could affect the adhesion of the vinyl.
Place the design sticky side down onto the surface and scrape well with your scraper to ensure it has good adhesion. If you lay the vinyl down in one spot first and roll it down as you scrape it will help to avoid any trapped air bubbles, making for a smooth finish.
Carefully remove your transfer tape and store for later use.
Admire your project.
12 x 12 Inch = 30.5 x 30.5 cm = 305 x 305 mm
12 x 24 Inch = 30.5 x 61 cm = 305 x 610 mm